LATEST Cisco 650-987 EXAM QUESTIONS [2018 DUMPS]

Vendor Cisco
Exam Code 650-987
Full Exam Name Cisco Data Center Unified Computing Design Specialist
Certification Name Cisco Certified Network Professional Data Center
Technology Customer Networking Services

♥ 2018 Valid 650-987 Exam Questions ♥

650-987 exam questions, 650-987 PDF dumps; 650-987 exam dumps:: 650-987 Dumps (50 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 650-987 Exam Questions:

Question: 21

A network engineer deployed a switch that operates the LAN base feature set and decides to use the SDM VLAN template. The SDM template is causing the CPU of the switch to spike during peak working hours. What is the root cause of this issue?

A. The VLAN receives additional frames from neighboring switches.
B. The SDM VLAN template causes the MAC address-table to overflow.
C. The VLAN template disables routing in hardware.
D. The switch needs to be rebooted before the SDM template takes effect.

Answer: C

Question: 22

An access switch has been configured with an EtherChannel port. After configuring SPAN to monitor this port, the network administrator notices that not all traffic is being replicated to the management server. What is a cause for this issue?

A. VLAN filters are required to ensure traffic mirrors effectively.
B. SPAN encapsulation replication must be enabled to capture EtherChannel destination traffic.
C. The port channel can be used as a SPAN source, but not a destination.
D. RSPAN must be used to capture EtherChannel bidirectional traffic.

Answer: C

Question: 23

Refer to the exhibit.

What is the result of the configuration?

A. The EtherChannels would not form because the load-balancing method must match on the devices.
B. The EtherChannels would form and function properly even though the load-balancing and EtherChannel modes do not match.
C. The EtherChannels would form, but network loops would occur because the load-balancing methods do not match.
D. The EtherChannels would form and both devices would use the dst-ip load-balancing method because Switch1 is configured with EtherChannel mode active.

Answer: B

Question: 24

A network engineer tries to configure storm control on an EtherChannel bundle. What is the result of the configuration?

A. The storm control settings will appear on the EtherChannel, but not on the associated physical ports.
B. The configuration will be rejected because storm control is not supported for EtherChannel.
C. The storm control configuration will be accepted, but will only be present on the physical interfaces.
D. The settings will be applied to the EtherChannel bundle and all associated physical interfaces.

Answer: D

Question: 25

What is the function of NSF?

A. forward traffic simultaneously using both supervisors
B. forward traffic based on Cisco Express Forwarding
C. provide automatic failover to back up supervisor in VSS mode
D. provide nonstop forwarding in the event of failure of one of the member supervisors

Answer: D

New Updated 650-987 Exam Questions 650-987 PDF dumps 650-987 practice exam dumps: https://www.dumpsschool.com/650-987-exam-dumps.html