LATEST Cisco 300-475 EXAM QUESTIONS [2018 DUMPS]

Vendor Cisco
Exam Code 300-475
Full Exam Name Cisco Cloud with Application Centric Infrastructure
Certification Name Cisco Certified Network Professional Cloud
Technology Cloud Application

♥ 2018 Valid 300-475 Exam Questions ♥

300-475 exam questions, 300-475 PDF dumps; 300-475 exam dumps:: 300-475 Dumps (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-475 Exam Questions:

Question: 26

After UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This port continues to reestablish until after eight failed retries. The port then transitions into the errdisable state. Which option describes what causes the port to go into the errdisable state?

A. Normal UDLD operations that prevent traffic loops.
B. UDLD port is configured in aggressive mode.
C. UDLD is enabled globally.
D. UDLD timers are inconsistent.

Answer: B

Question: 27

After reviewing UDLD status on switch ports, an engineer notices that the.” Which statement describes what this indicates about the status of the port?

A. The port is fully operational and no known issues are detected.
B. The bidirectional status of “unknown” indicates that the port will go into the disabled state because it stopped receiving UDLD packets from its neighbor.
C. UDLD moved into aggressive mode after inconsistent acknowledgements were detected.
D. The UDLD port is placed in the “unknown” state for 5 seconds until the next UDLD packet is received on the interface.

Answer: A

Question: 28

Pilot testing of the new switching infrastructure finds that when the root port is lost, STP immediately replaces the root port with an alternative root port. Which spanning-tree technology is used to accomplish backup root port selection?

A. PVST+
B. PortFast
C. BackboneFast
D. UplinkFast
E. Loop Guard
F. UDLD

Answer: D

Question: 29

A network engineer must adjust the STP interface attributes to influence root port selection. Which two elements are used to accomplish this? (Choose two.)

A. port-priority
B. cost
C. forward-timers
D. link type
E. root guard

Answer: A, B

Question: 30

A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?

A. Configure the new load balancing method using port-channel load-balance.
B. Adjust the switch SDM back to “default”.
C. Ensure that IP CEF is enabled globally to support all load balancing methods.
D. Upgrade the PFC to support the latest load balancing methods.

Answer: A

New Updated 300-475 Exam Questions 300-475 PDF dumps 300-475 practice exam dumps: https://www.dumpsschool.com/300-475-exam-dumps.html

Facebook Comments