Latest Cisco CCNP Data Center 300-165 EXAM QUESTIONS [Dec-2017 Dumps]

Cisco 300-165 exam is very helpful for applicants to identify Data Security Manager, Data Storage Administrator and Network Routing & Switching Expert. Applicants will also learn how to improve Implement Routing and Switching Protocols. Applicants, who will clear this 300-165 Cisco Certified Network Professional Data Center certification exam, will receive CCNP Data Center certifications. CCNPtips provides you updated 300-165 exam questions for your 300-165 exam preparation.

300-165 exam questions, 300-165 PDF dumps; 300-165 exam dumps:: (165 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-165 Exam Questions:

Question: 12

Which two options can be used for link aggregation when you configure vPC member interfaces? (Choose two.)

A. a static EtherChannel
B. the Cisco Fabric Services protocol
C. the LACP protocol
D. the VSL control link
E. the PAgP protocol

Answer: C,D

Question: 13

Which two options should you consider when you configure a SAN zone set? (Choose two.)

A. VSANs can be activated by using enhanced zoning.
B. A SAN zone set consists of one or more SAN zones.
C. A SAN zone set must be activated manually on all of the fabric nodes.
D. Only the SAN zone set can be activated simultaneously.
E. One SAN zone can be the member of only one zone set.

Answer: B,C

Question: 14

Which technology is required in the underlay to facilitate remote VTEP discovery?

A. multicast

Answer: A

Question: 15

New Updated 300-165 Exam Questions 300-165 PDF dumps 300-165 practice exam dumps:

Which statement about SNMP support on Cisco Nexus switches is true?

A. Cisco NX-OS only supports SNMP over IPv4.
B. Cisco NX-OS supports one instance of the SNMP per VDC.
C. SNMP is not VRF-aware.
E. Only users belonging to the network operator RBAC role can assign SNMP groups.

Answer: B

Cisco NX-OS supports one instance of the SNMP per virtual device context (VDC). By default, Cisco NX-OS places you in the default VDC. SNMP supports multiple MIB module instances and maps them to logical network entities. SNMP is also VRF aware. You can configure SNMP to use a particular VRF to reach the SNMP notification host receiver. You can also configure SNMP to filter notifications to an SNMP host receiver based on the VRF where the notification occurred.

Question: 16

Which command should you ran to distribute NTP configuration changes by using Cisco Fabric Services?

A. ntp distribute
B. ntp server
C. ntp commit
D. ntp authenticate

Answer: A

Question: 17

You are connecting a Cisco Nexus 2300 Series FEX to a Cisco Nexus 5600 Series parent switch. Which command should you use to configure the interfaces on the Nexus switch that connects to the FEX?

A. switch(config-if)# switchport mode f
B. switch(config-if)# switchport mode fex-fabric
C. switch(config-if)# switchport mode fabricpath
D. switch(config-if)# switchport mode vntag

Answer: B

Question: 18

On a Cisco Nexus 7000 Series router, which statement about HSRP and VRRP is true?

A. When VDCs are in use, only VRRP is supported.
B. HSRP and VRRP both use the same multicast IP address with different port numbers.
C. HSRP has shorter default hold and hello times.
D. The VRRP group IP address can be the same as the router-specific IP address.

Answer: D

VRRP allows for transparent failover at the first-hop IP router by configuring a group of routers to share a virtual IP address. VRRP selects a master router in that group to handle all packets for the virtual IP address. The remaining routers are in standby and take over if the master router fails.

Question: 19

What is the Overlay Transport Virtualization site VLAN used for?

A. to facilitate communications between OTV edge devices within the site
B. to allow multiple site AEDs to communicate with each other
C. to detect devices at the site that are not capable of OTV
D. to allow the join interfaces at different sites to communicate

Answer: C

The edge device performs OTV functions: it receives the Layer 2 traffic for all VLANs that need to be extended to remote locations and dynamically encapsulates the Ethernet frames into IP packets that are then sent across the transport infrastructure. It is expected that at least two OTV edge devices are deployed at each data center site to improve the resiliency.

Question: 20

Which Cisco MDS feature needs to be enabled for Cisco TrustSec FC Link Encryption to work?

A. feature Trust-Sec
B. feature ESP
C. feature FC-TSLE
D. feature FC-SP

Answer: D

Facebook Comments